You’ll wanna Make so many of these beaded rings. Here’s how to make them…
Here’s another method you can use to make a ring! This DIY beaded ring is easy to make because it requires no findings at all, just some beads and wire. This beaded ring design is perfect for layering along with your favorite jewelry to create a look that is uniquely you. Please note that this tutorial contains affiliate links. I hope you fine some fun beads to make this design :).
You will need the following tools and materials to make this ring:
1. Cutting pliers
3. Assorted seed beads. I used two different colours to make a simple pattern.
The Steps
1. Cut some wire. Measure the length you need by wrapping it around your finger. Remember to add a little extra to make sure it fits. I cut my wire to 12cm long (4.7 inches)
2. Add the first bead.
3. Thread the other end of the wire through the bead in the opposite direction forming a loop. Pull on one end so that the loop closes and the bead is fixed into place.
4. Add the rest of the beads to your desired length in your chosen pattern.
5. Thread the short end of the wire through the last bead you threaded.
6. Loop the long end around the opposite side of the bead and then pull it tight like you did on the first bead.
7. wrap the ends of the wire securely around the ring on either side of the fixed beads. Trim off any excess wire. Dab on some clear nail polish to each wrapped end to help keep them secure.
8. Now your beaded ring is finished. These DIY rings are so easy to make you’ll run out of fingers to wear them on!
You can find some more DIY rings here 😉