These wire threader earrings feature delicate beads, kept in place by hammering some wire flat. Contains affiliate links.

You will need the following tools and materials to make these earrings:

1: Pliers. You will need wires with a square bending nose without ridges so that you don’t mark the wire. You will also need your cutting pliers to cut the pieces of wire.

2: Two pieces of wire. Approximately 8cm long. I used some gold-fill wire.

3: A file.

4: A steel block.

5: A hammer.

6: Beads of your choice. I used these star shaped shell beads and these round hematite beads.

https://amzn.to/3AHeEno

Follow these steps to make your earrings:

1: Hammer one end of each piece of wire. Hammer on the steel block and continue to flatten the wire until it is wide enough to stop your beads from sliding off. Repeat this step for the second piece of wire so that both pieces have one flattened end.

2: File each of the wire ends so that none are sharp or rough.

3: Add the beads to each of the wires.

4: Hold one of the wires with the plastic nose pliers.

5: Bend one side of the wire around the angle of the pliers to form a right angle.

6: Bend the other side around the pliers to form another right angle. This will form a square shape that makes the top of your earring.

7: Repeat steps 4-6 for the second earring.

8: If your wire had some curve to it like mine did you can straighten it out gently using your pliers and fingers.

Once your earrings are straight then they are finished and ready to wear! How amazing are they? So delicate and simple.