This choker necklace can also be worn as a cool bracelet. It’s super cool and easy to make.

You will need the following tools and materials to make your choker/bracelet:

1: Pliers. You will need your flat nose pliers, round nose pliers and cutting pliers to make this choker/bracelet.

2: A piece of leather or faux leather long enough to fit closely around your neck.

3: Two flat crimp ends.

4: Two jump rings.

5: A toggle clasp.

https://amzn.to/3wHDLoL

6: A head pin.

7: A bead or charm of your choice. I used this glass bead.

Follow these steps to make your convertible choker bracelet:

1: Add a crimp to each end of the leather, securing it in place by squeezing it around the leather using the flat nose pliers.

2: Add a jump ring to one end and attach one part of the toggle clasp.

3: Add the other jump ring and the second part of the clasp to the other end of the leather.

4: Put the bead onto the head pin.

5: Bend the head pin so that it is at a right angle to the bead using the round nose pliers.

6: Trim the end of the pin if required (it should extend approximately 1cm from the top of the bead). If no trimming is required, curl the pin into a loop using the round nose pliers.

8: Open the charm loop slightly and attach the charm to one of the jump rings that connects the leather and the clasp.

9: Close the charm loop to secure it in place. Once your charm is secured in place your creation is ready to wear, either as a choker or a bracelet!

Here’s the design worn as a bracelet.

And here it is as a choker necklace.