This Circle Pendant Is Simple and Beautiful, Load Yours up With Your Favorite Beads!

The highlight of this necklace is a lovely beaded circle pendant! You can use all kinds of lovely beads to make this design your own. note: contains affiliate links.

You will need the following tools and materials to make your necklace:

1: Pliers. You will need your cutting pliers, round nose pliers and flat nose pliers to make your necklace.

https://amzn.to/3CnQi2A

2: Wire. I used some copper wire to make my circle pendant. I cut mine to approximately 12cm in length.

https://amzn.to/3RMuZxp

3: Three jump rings.

https://amzn.to/3Cs9WL8

4: A piece of chain at the length you want your necklace. I used copper chain to match the wire.

https://amzn.to/3pWSto5

5: A lobster clasp. I used this copper colored one.

https://amzn.to/3Mh1raa

6: Beads of your choice. I used some red glass seed beads and some small timber beads.

https://amzn.to/3EscmvG

https://amzn.to/3T3SZx0

Follow these steps to make your circle pendant necklace:

1: Create a loop at one end of the wire using the round nose pliers.

2: Add the beads to the wire in your choice of pattern.

3: Continue beading until there is approximately 1cm of wire remains unbeaded.

4: Bend the end of the wire so that it is at a right angle to the beaded section.

5: Create a loop at the end of the wire using the round nose pliers.

6: Attach the two loops together and close them to create a circle shape. You might need to gently reshape the loop to make it more of a circle shape.

7: Attach a jump ring to one of the loops at the top of the circle pendant.

8: Slide the ends of both chains onto the open jump ring.

9: Close the jump ring to secure the chain in place.

10: Split the chain in the middle opposite the place where the pendant is attached.

11: Add a jump ring to one side of the chain and add the lobster clasp. Close the jump ring to secure the lobster clasp in place.

12: Add the remaining jump ring to the other side of the chain to finish the necklace!