Get ready for the warm months with this chunky cord anklet!

There’s nothing like an anklet for getting you into a relaxed mood. It’s the perfect accessory for warm summer nights (or any time really)! This anklet has been made out of some cord recycled from a shopping bag, so you can make your purchases go even further!

You will need the following tools and materials to make your anklet:

1: Pliers. You will need your flat nose pliers and round nose pliers to make this anklet.

3: A piece of chunky cord cut to length so that it fits comfortably around your ankle. I used this black piece of cord from a shopping bag.

4: Two flat crimp ends, approximately 1cm (approximately 0.4 inches).

5: Two jump rings.

6: A lobster clasp.

https://amzn.to/3CBYdLo

Follow these steps to make your chunky cord anklet.

1: If you need to, trim your piece of cord so that it fits around your ankle.

2: Take one of the crimp ends and place it on one end of the cord.

3: Use the flat nose pliers to squeeze the crimp end around the cord, securing it in place.

4: Repeat steps 2 and 3 for the remaining crimp on the other end of the cord.

5: Add a jump ring to one end of the anklet, slide the lobster clasp onto the open jump ring and close it to secure the clasp in place.

6: Add the other jump ring to the other end of the anklet, closing it using your pliers.

Once the final jump ring is in place your anklet is finished and ready to wear. You could add some charms to your anklet for some extra pizazz!

Save

Save