The double hole bead is back! This bracelet is delicate and adorable.

The double hole bead strikes again! Make a bracelet to match your necklace using a double hole bead and some delicate chain.

You will need the following tools and materials to make your bracelet:

1: Pliers. You will need your round nose pliers, flat nose pliers and cutting pliers to make this bracelet.

https://amzn.to/3dYrfus

2: Two small eye pins.

https://amzn.to/3Rq54fl

3: Two pieces of chain that fit comfortably around your wrist (maybe a bit on the tight side).

4: Two jump rings.

5: A toggle clasp.

6: A bead of your choice that has two holes. I used this blue glass bead.

Follow these steps to make your bracelet:

1: Add one of the pins to one of the holes in the bead.

2: Bend the pin at a right angle to the bead using the round nose pliers.

3: Loop the pin to secure it on the bead using the round nose pliers.

4: Repeat steps 1-3 for the second pin.

5: Add a piece of chain onto one of the pin loops.

6: Add the other side of the chain to the corresponding pin end on the other side of the bead.

7: Repeat steps 5-6 for the second piece of chain.

8: Split both chains in the middle opposite the bead charm.

9: Use a jump ring to attach two parallel chains together and add one part of the toggle clasp. Close the jump ring to secure the clasp component in place.

10: Repeat step 9 for the other side of the bracelet, securing the remaining clasp component in place.

Now your bracelet is finished! How cute is it?!